Firewood Rack
Draft · not yet checked by a carpenterA 4 ft rack that keeps about a third of a face cord of firewood off the ground. A few 2x4s and a pocket-hole jig.
- Skill
- Beginner
- Build time
- 2 to 3 hours
- Lumber
- 4 2x4s
- Joinery
- Pocket holes
- Finished size
- 48″ W × 16″ D × 36″ H
A 2x4 is actually 1½″ × 3½″. Every measurement in this plan uses the real size.
Shopping list
- 4Pressure-treated 2x4, 8 ftPressure-treated, rated for ground contact.
- ~402½″ exterior-rated pocket-hole screwsCoated, made for treated lumber.
- opt.Pavers or gravelTo set the rack on.
Tools
- Miter saw or circular saw
- Pocket-hole jigSet for 1½″ material.
- Drill/driver
- Speed square, tape measure, pencil
- Dust maskFor cutting treated lumber.
Cut list
| Part | Qty | Size, inches | From |
|---|---|---|---|
| AUprights | 4 | 1½ × 3½ × 36 | 2x4 |
| BEnd cross pieces | 4 | 1½ × 3½ × 9 | 2x4 |
| CBottom rails | 2 | 1½ × 3½ × 45 | 2x4 |
| DTop rail | 1 | 1½ × 3½ × 45 | 2x4 |
Board layout. Each row is one board, cut left to right, with the remainder hatched. Dark lines are saw cuts, about ⅛″ wide.
Build it
01Cut the pieces
Cut every piece from pressure-treated 2x4s:
- A Uprights, four at 36″
- B End cross pieces, four at 9″
- C Bottom rails, two at 45″
- D Top rail, one at 45″
Watch outBuy lumber rated for ground contact: the bottom rails sit right on the ground. Wear a dust mask when you cut treated wood and don't burn the offcuts.
02Drill the pocket holes
Set your jig for 1½″ material and drill 2 holes at each end of every cross piece (B), bottom rail (C) and the top rail (D), all on one face. Those faces go on the inside.
03Build the two end frames
Lay two uprights (A) on the bench, wide faces up. Fit an end cross piece (B) between them at the bottom and another at the top, flush with the ends and the faces, pocket holes up. Drive 2½″ exterior pocket screws.
Measure the frame corner to corner both ways and push it square before the last screws. Build the second frame to match.
04Add the bottom rails
Stand the frames up, 45″ apart, pocket holes facing in. Fit the two bottom rails (C) between the uprights, flush with the bottoms and the outside faces. Screw them in.
The firewood sits on these two rails, clear of the ground.
05Add the top rail
Fit the top rail (D) between the back uprights, flush with the tops and the back faces, and screw it in. It ties the frames together and keeps the back of the stack straight.
06Set it up and stack it
Set the rack on level ground, ideally on a few pavers or a bed of gravel so the rails stay dry. Keep it a couple of feet from the house.
Stack the wood tight against both end frames, bark side up. A full rack holds about 14 cubic feet, about a third of a face cord. Cover the top only, so air can still move through the sides.
TipLoad the ends first and work toward the middle. A tight stack braces the rack.
Build at your own risk. Check every measurement against your own lumber before you cut, test-fit before you glue, and wear eye and ear protection.